Mount adaptor ring to launcher CE unit (pneumatic launcher). Connect pressurized air with the quick release coupling. (Recommended pressure: 6-10 kg/cm2, Recommended discharge volume: 4L/minute)

Go to Pneumatic Launcher Price

Select a nozzle that fits perfectly to the end surface of the hoses, tubes and pipes and connect it to the adaptor ring (28 kinds of each type are available).

Go to Nozzle Price List

Load suitable projectile for objective to the nozzle. A projectile that is 20% larger than the inside of the hoses, tubes or pipes should be used.

(Example: A 40mm projectile for 32 mm radius)
Projectile selection method is such that Standard S with coupling is normally used, and in the case where a coupling is attached the coupling projectile C is used, and for metal pipes etc, abrasive A or grinding G is used depending on the level of contamination.

Go to Projectile Price List

Place projectile receiving plate at exit of tube.
Place nozzle securely on the hoses, tubes or pipes and pull the lever.
If the level of contamination is high, first pass the coupling projectile through as this passes through easily, then pass through the standard projectile. Always pass the projectile through from both ends alternately. In the projectile becomes lodged inside, apply air pressure from the opposite side using a launcher and it will come back out easily.

Launch away from other people.
Wear protective goggles while operating.